Product details
Stainless A-Pillar Ditch Light Brackets for Toyota Tacoma 4th Gen (2024+)
Put light where the trail actually needs it. These ditch light brackets for the 4th Generation Toyota Tacoma mount a pair of pod lights at the base of the windshield, throwing light wide into the corners, switchbacks and shoulders your headlights miss.
Each bracket is laser cut from 4mm stainless steel. It won't flex, rattle or shake your lights out of aim on washboard roads, and it won't rust or need repainting after a season of mud, salt and car washes. The low-profile design sits tight to the A-pillar, does not obstruct the front windshield like some other ditch lights, and minimizes hood glare, so it looks like it came from Toyota.
Why We Mount to the Fender, Not the Hood
Most ditch light brackets bolt to the underside of the hood. Ours mount to a factory location on the inner fender instead, and that makes a big difference:
- Easier install: one factory bolt per side and you're done, so it goes on significantly faster than a hood-mounted bracket.
- Way less vibration: your lights stay steady and aimed on rough trail.
- No hood deflection: nothing rides on the hood, so the lights don't move when it flexes.
- Clear view: the fender location lets us tuck the light behind the A-pillar, out of your line of sight, with minimal hood glare.
It all adds up to the sleekest, most low-profile ditch light on the market.
Features
- Precision laser cut from 4mm stainless steel
- Corrosion resistant, with no coating to chip or peel
- Direct fit for the 2024+ Toyota Tacoma (4th Gen)
- Bolt-on install using factory mounting points, no drilling
- Low-profile design that follows the lines of the truck
- Designed and built by Tiny Rig Co
Fitment
- 2024+ Toyota Tacoma (4th Gen), all trims and years. No exclusions.
- Will fit with Trailhunter Air Intake Snorkels
What's Included
- 2 x stainless A-pillar brackets (driver and passenger)
- New M6 button-head mounting hardware
- Lights not included
Installation
A simple 10-minute install with a 10mm socket and ratchet.
- Pull back the rubber trim to expose the M6 fender bolt.
- Remove the bolt, align the bracket, and tighten the new M6 bolt into place.
- Mount your light on the bracket.
- Run the wires into the engine bay under the rubber trim.
Pairs With
Designed around Baja Designs S1, S2, Squadron and Squadron 2.0 pods. Similar-size pods from Diode Dynamics, KC HiLiTES, Morimoto and others also fit.
Shipping & Lead Time
In stock and ready to ship.